Tech section strictly for the FJR. Everything from oil changes & suspension setup's to removing sheep hair from hard to reach places on the bike so that your wife never finds out.
RIP - JWilly - aka Jason - Memories and Tributes
Replies: 252
by
extrememarine »
Sat May 21, 2022 11:52 pm
» in
Notices
First post
Good evening.
Last post
I got back in the office this week after the power outages and a quick trip out west with the Mrs. Flipped the calendar over to July and I was sad....
252 Replies
311646 Views
Last post by Cav47
Tue Jul 11, 2023 6:20 pm
Where is the “Off Topic” area?
Replies: 17
by
extrememarine »
Fri Jan 18, 2013 9:47 pm
» in
Introductions
First post
Where is the “Off Topic” area?
Last post
Please ensure you're wearing your big person panties if you step into that end of the pool...
17 Replies
52016 Views
Last post by extrememarine
Tue Sep 03, 2019 8:34 pm
Possible Failing Ignition Lock
Replies: 21
by
bill lumberg »
Mon Nov 15, 2021 11:20 am
First post
I’ve always kept my locks lightly lubed. Never an issue. Then, after a long day in the mountains, zero issues, the next morning, the bike is almost...
Last post
After irrigation, I blew it out with compressed air. No difference, but I did find that, if I rotate the key outward, in a clockwise fashion, almost...
21 Replies
1787 Views
Last post by bill lumberg
Wed Nov 17, 2021 4:56 am
Mileage after changing oil for winter storage
Replies: 21
by
CollingsBob »
Thu Oct 14, 2021 4:33 pm
First post
Ok…a bunch of you ‘muricans can just ignore this.
Last post
Don't know how much I agree with all of the Amsoil winterizing instructions. Advertizing to sell Amsoil stuff .
21 Replies
1632 Views
Last post by FJRoss
Wed Nov 10, 2021 9:38 pm
Inverted Forks on Gen 1
Replies: 2
by
Canadian FJR »
Wed Nov 03, 2021 7:44 pm
First post
Could one install a new Gen front end on a Gen 1 by simply replacing the steering head, inverted forks and wheel?
Last post
Qualified maybe, but for GEN I would be a difficult swap. Not straightforward and likely not worth the cost and aggravation. First, whole front...
2 Replies
550 Views
Last post by escapefjrtist
Wed Nov 03, 2021 10:03 pm
Bend R-Gaza Saddlebag Bars?
Replies: 4
by
Ludwig61 »
Sat Oct 30, 2021 6:24 pm
First post
Hello!
Last post
I had ordered another set from Amazon before I posted this, in case I couldn't find workable bending advice. Rather than flex it towards weakness for...
4 Replies
667 Views
Last post by Ludwig61
Mon Nov 01, 2021 7:09 pm
Oil change kit
Replies: 4
by
Boston »
Sun Oct 24, 2021 10:49 am
First post
I do not know if anybody talked about this before. (didn't bother to look)
Last post
If the kit isn't model-specific, it is possible that the other crush washers are for different bikes. AFIK, the fill hole and drain for the final...
4 Replies
745 Views
Last post by Boston
Fri Oct 29, 2021 9:03 am
Tech Day in North Georgia
Replies: 26
by
Toter »
Fri Oct 15, 2021 7:34 pm
First post
Hey guys. Talked to Andy at EOM, thinking about doing a tech day at my place here in North Georgia. I am not a tech guru. Would need them to come and...
Last post
Not sure if Jwilly or Lumberg have tire machines.
26 Replies
2056 Views
Last post by BikerGeek
Fri Oct 22, 2021 4:10 pm
Aftermarket wave rotors
Replies: 41
by
dcarver »
Sun Jun 27, 2021 7:01 pm
First post
KrZy8, 247k miles, stock rotors.. hard to believe, but they are under minimal width.
Last post
Too bad EBC doesn't make rotors for the Audi RS3. To save weight, they thinned the rotors to a minimum. You can't turn them even once.
41 Replies
4715 Views
Last post by Bounce
Tue Oct 19, 2021 10:58 am
Where is the paint code?
Replies: 2
by
2WheelJon »
Sun Sep 12, 2021 8:00 pm
First post
Got to do a little touch up on my 2007 FJR. Where do I find the paint code?
Last post
Found Colorite and ordered the paint from them.
2 Replies
1097 Views
Last post by 2WheelJon
Mon Sep 13, 2021 7:50 pm
Power tap location
Replies: 8
by
fencer »
Sat Sep 11, 2021 3:18 pm
First post
What is the suggested location and wire code to tap into for a key switchable on relay for electronic add ons?
Last post
Admore Lighting plug and play harness here. No taps, no splices.
8 Replies
1567 Views
Last post by rbentnail
Sun Sep 12, 2021 9:16 pm
Strange engine sound
Replies: 66
by
Cav47 »
Thu Aug 12, 2021 8:11 pm
First post
Background: Went up to my regular poker game on Wednesday night on the FJR. (Cashed out up $71 dollars up btw).
Last post
Did you find all my boogers in there?
66 Replies
7487 Views
Last post by Cav47
Wed Aug 25, 2021 8:14 am
Wouldn't start.......then it did
Replies: 32
by
2WheelJon »
Fri Aug 06, 2021 8:19 pm
First post
I have a 2007 FJR with 20,000 miles on it. It has a new battery and the connections on it are tight. The ignition switch, ECU and spider ground...
Last post
Dielectric grease loaded into the back of the connector... don't use silicone sealant.
32 Replies
3705 Views
Last post by mcatrophy
Sat Aug 21, 2021 9:03 am
Loose wire connector
Replies: 4
by
Atrious »
Sat Aug 14, 2021 5:17 pm
First post
I was disconnecting an accessory off of the battery on my 2009 when so came across a small ring wire connector. It is too small to fit on the...
Last post
And it really should be pointing up. For Gen3, they put a screw in it, even higher and on the mirror stay.
4 Replies
1031 Views
Last post by raYzerman
Sat Aug 14, 2021 10:28 pm
Help! Trying to remove driveshaft oil seal.
Replies: 5
by
RacinRay »
Sat Jul 24, 2021 4:16 pm
First post
I had gear oil leaking from the weep hole in the swingarm so I bought a new oil seal for the driveshaft. I got the driveshaft out of the final drive...
Last post
There is coupling in there that the seal rides on. If there is a groove in it it needs to be replaced.
5 Replies
1265 Views
Last post by Canadian FJR
Sun Jul 25, 2021 3:12 pm
Error Code 42 (KrZy8) Gen II
Replies: 31
by
dcarver »
Tue Jun 08, 2021 2:02 pm
First post
Looking for Advice, Suggestions, Ridicule!
Last post
Found the Smoking Gun
31 Replies
4461 Views
Last post by mcatrophy
Mon Jun 21, 2021 4:37 am
Tank bolts......OH #$#@!!
Replies: 29
by
Steel_Gin »
Sun Jun 06, 2021 3:56 pm
First post
I can't believe this happened but it has. I have always been careful removing the two hex bolts that are at the top of the tank and can't point to a...
Last post
The ones that I have to be careful about are the two short Allen bolts that hold the plastic tank trim in place. VERY easy to get these going at the...
29 Replies
3699 Views
Last post by gixxerjasen
Thu Jun 10, 2021 11:13 am
Gen 1 Fork Rebuild
Replies: 9
by
Festus »
Mon May 31, 2021 8:38 am
First post
Looked like a good set of videos on doing the rebuild. Some interesting tips. I hadn't seen it before and couldn't find where it had been posted...
Last post
My Formula 409 squirt pump is 20 years old. Put away wet after use.
9 Replies
1472 Views
Last post by N4HHE
Tue Jun 01, 2021 7:16 pm
Mystery part...
Replies: 1
by
FJRoss »
Tue Jun 01, 2021 6:57 pm
First post
Not the first time this sort of thing has happened. Last week I found a small stainless steel washer on the garage floor and I have no idea where it...
Last post
Found it!!
1 Replies
839 Views
Last post by FJRoss
Tue Jun 01, 2021 7:04 pm
Gas Cap Ball Ectomy
Replies: 12
by
Canadian FJR »
Sun May 23, 2021 1:02 pm
First post
I know there use to be several threads on this but I spent the last two hours looking and can’t find them.
Last post
Or
12 Replies
1824 Views
Last post by dcarver
Fri May 28, 2021 11:28 am
Cooling problem
Replies: 32
by
FjrVfr »
Thu Mar 25, 2021 8:46 am
First post
I've got a Gen 2 (2012) with about 80K on the clock. In 4th or 5th gear at speed everything's fine. My temp gauge reads 4 or 5 bars out of 10. When I...
Last post
I may try that though I don't know of a good radiator shop offhand.
32 Replies
3779 Views
Last post by BikerGeek
Mon May 24, 2021 1:43 pm
Spokane, WA area service
Replies: 3
by
RodBarnes »
Sat May 15, 2021 4:45 pm
First post
I moved to near Diamond Lake, WA (USA, Zip 99156, North of Spokane) and wonder if anyone has recommendations for a reputable mechanic for servicing...
Last post
Well...... there is this annual event called a tech day in Auburn..... not sure when the next one is, but if you hang around with those knowledgeable...
3 Replies
1011 Views
Last post by Auburn
Sat May 15, 2021 9:39 pm
TBS port Rubber Caps and Clips
Replies: 5
by
FJRoss »
Sat May 01, 2021 10:27 am
First post
What does anyone use for replacements for these? On-line parts place quotes:
Last post
1/8 /3mm good, 5/32 OK too. I have used leftover caps from SpeedBleeders. You'll find the ones at the auto supply are much thicker wall, no worries...
5 Replies
1263 Views
Last post by raYzerman
Sat May 01, 2021 9:15 pm
Valve Check Time!
Replies: 46
by
FJRoss »
Mon Apr 26, 2021 8:35 pm
First post
I bought the bike (used) three years ago. The previous owner did a valve check at 42,000 km (26,250 miles) and didn't make any changes. I have...
Last post
It would actually be difficult to be more than one tooth off with a shim or CCT change.... two teeth off might cause interference but I don't know...
46 Replies
4756 Views
Last post by raYzerman
Sat May 01, 2021 9:11 pm
Transmission recall
Replies: 369
by
FJRoss »
Fri Dec 04, 2020 3:20 pm
First post
Link for Canadian bikes (2016-2020 model years)...
Last post
To be honest I don’t think there is any difference
369 Replies
36854 Views
Last post by Canadian FJR
Mon Apr 26, 2021 7:28 pm
TPS Replacement Woes
Replies: 13
by
Powerman »
Sat Mar 13, 2021 8:11 pm
First post
Chasing intermittent issues I thought I would try a TPS. (still working)
Last post
About the Gen III TPS
13 Replies
2114 Views
Last post by ionbeam
Fri Apr 23, 2021 8:25 am
ABS Block Forensics '06-'07
Replies: 4
by
raYzerman »
Sun Apr 11, 2021 4:01 pm
First post
Reviving my attempt to see how to dissassemble since it's been 3 years since I looked at it... just confirming my conclusion then that it wasn't...
Last post
Those metal balls or what was thought to be pins are Koenig style expander plugs.
4 Replies
1118 Views
Last post by N4HHE
Tue Apr 13, 2021 11:10 am
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forum
